Discription
Teamlink-3108EE is intelligent converter connecting fast ethernet LANs over E1 circuits.
They enable service providers and ISPs to supply transparent ethernet services, without interfering with user traffic.
The 802.1 priority scheme enables users to define four different QoS levels, according to the application
requirements.
The fast ethernet handles frame size setting to 1522, 1526, 1654, 1784 bytes
Features
Connects fast Ethernet LANs over E1 circuits.
Inband and out-of-band management access vis: ASCII terminal, Telnet, SNMP, Teamview - EMS
Wire-speed packetforwarding
4-levels of QoS, based on four VLAN priority queues as per 802.1p
Ethernet Frame size settings
VLAN Tagging Un Tagging.
MAC table Display
Ethernet transmit,Receive,Collision and error packets display
Ethernet Rate Controle.
Special tag for the management traffic that will transmit in the same traffic to ensure the inband management functions.
Enables the higher bandwidth capacity Ethernet Services to Remote locations.
TEAMLINK 3102 uses next generation Ethernet Over PDH network protocols, Virtual Concatenation and Link Capacity adjustment scheme.
Inter operable with the any device which is using the standard Protocols like GFP,VCAS,LCAS for connectiong.
VLAN - aware and VLAN - Unaware operation.
Wire speed packet forwarding based on No.of E1s.
Delay Compensation up to 255ms among the E1.
Self-Learing Ethernet Briding
QOS based on VLAN Priority
Technical Specifications
Sends Alarm notification to Manager IP address for the following
E1: Up / Down
Ethernet : Up / Down
Loopback : On / Off
If the ethernet error packets or collusion packets are reached more than threshold values.
E1 Interface Specifications
Number ports : 8
Compliance : G.703 / G.704
Data rate : 2.048 Mbps
Line Code : HDB3, AMI
Line Impedance : 120 Ohms, balanced
System Clock : Internal or loopback timing
Diagnostics : Remote and local loopback
Connector : RJ-45
Ethernet Interface Specifications
Type: 10/100 Base-TX and 100 Base-FX Mbps auto negotiation, full/half duplex, flow control.
Compliance : Confirms to the relevant sections of IEEE 802.3 and 802.3U
Connector : RJ-45 and LC type for fiber.
WAN Protocol
TEAMLINK 3108 uses next generation Ethernet Over PDH network protocols, Virtual Concatenation and Link Capacity adjustment scheme.
Type : GFP(VCAT & LCAS)
CRC Type : 16 or 32 bit selection.
Built-In Power:
Dual Mode AC/DC, 230VAC +/- 10% & –48VDC +/-10%
Power consumption:
< 2W
Temperature:
-5 To 50°C
Humidity:
Upto 95% non condensing at 35°C
