TEAMLINK3002 SHDSL is a LAN Extender modem with an Operating Range of : 6Km on 0.5mm dia copper cable @ 2.048Mbps in 2 wire operation, 7.5Km on 0.5mm dia copper cable @ 2.048Mbps in 4 wire operation and 11Km on 0.5mm dia copper cable @ 64Kbps in 2 wire operation.
Embedded Operational channel(EOC) for controlling and monitoring remote unit
Provides multi stage line protection as per K.20 and K.21
External Secondary optional Line Protection Device
Long reach up to 11Km for standard 64Kbps speed
Interchangeable user interface cards in the same modem and field upgradeability
User interface cards can be ordered optionally depending on the field requirement
Noise Margin Indication for sensing line quality
Status monitoring using SNMP & TELNET
AC and DC built-in power supply
Line type : 4Wire (single pair operation)
Line Code : TCPAM as per the ITU-T G991.2
Line Impedance : 135 Ohms
Connector : RJ45
Transmit Signal Power : 3.5dBm +/- 0.5dBm
Operating Range : 6Km on 0.5mm dia copper cable @ 2.048Mbps in 2 wire operation, 7.5Km on 0.5mm dia copper cable @ 2.048Mbps in 4 wire operation and 11Km on 0.5mm dia copper cable @ 64Kbps in 2 wire operation.
Line protection : As per ITU-T K20 and K21
Transmit Level : Upto 14dBm
Line Code transmission
Specification : ANSI T1.601
Connector : RJ 45 and 3 Pin terminal Block.
No. of Ethernet ports : 4 (4 Port Switch), RJ45 connectors for UTP cables
Interface Compliance : IEEE802.3 Compliant
10Base-T and 100Base-TX support
2 K MAC address level filtering
Transparent Ethernet Bridge, Auto learning and aging
Auto Speed Sensing
Auto polarity detection
Management port operating speed 11500, No Parity and stop Bit.
Loop back, pattern generation, configuration and status monitoring shall be through switches and also through SNMP(Simple Network Management Protocol) and TELNET using Ethernet Management port.
Local Loopback, Digital Loopback and Remote Loopback as per the V.54
Built in test 511 pattern generation and checking.
Diagnostics & Monitoring through EOC Channel without interfering data transmission.
Loop backs, test pattern generation and checking using front panel switches.
SNMP Management Port & TELNET.
PWR, MR, COT, DSL LINK, ETH LINK ACT, SPD, PAT, ERR, TST, NMR
Dual Mode AC/DC, 230VAC +/- 10% & –48VDC +/-10%
-5 To 50°C
Upto 95% non condensing at 35°C
No. of Ethernet ports : 4 (4 Port Switch),
RJ45 connectors for UTP cables
Line Impedance : 135 Ohms
AC and DC built-in power supply
STransmit Signal Power : 3.5dBm +/- 0.5dBm
Auto Speed Sensing
SNMP Management Port & TELNET.
Auto polarity detection
Transmit Level : Upto 14dBm