Teamlink Ethernet to E1 Router will convert the Ethernet into E1 Protocol Level signal for connecting to the E1 Modems.
It Can be configured in bridge Mode as well as in routing Mode
Teamlink Ethernet to E1 Router will convert the Ethernet into E1 Protocol Level signal for connecting to the E1 Modems.
It Can be configured in bridge Mode as well as in routing Mode
In Bridge Mode HDLC framing will be sent over the E1 Interface with the CRC-16 for compatible with the Central MPLS Router
In Routing Mode Static Routing with the PPP Encapsulation
Easy Menu Driven Software For the Configuration and Status Monitoring
ICMP Ping Request and Replay for Easy Diagnostics
Managed Ethernet Port For the status monitoring and configuration in Telnet, SNMP
Automatic Detection of the Clock speed
DE1 UP and Down Condition. And Serial Interface Checking.
Loop back Detection at the DSL Level
Dual AC and DC power supply input from the Same Socket.
Complied according to the IEEE802.3
10Base-T and 100Base TX Support
Mac Address Filtering
Auto MDI-X Support
Recovered From E1
Internal Clock
ARP, RARP, ICMP
PPP, LCP, IPCP, IP
IPv4, TCP, UDP,TFTP
Number ports : 1
Bit Rate : 2.048Mbps
Line Coding : HDB3
Line Impedance : Balanced 120 Ohms
Interface Connectors : RJ45
Complies With : ITU G.703 and G.704.
System Clock : Internal or loop back timing
Serial UP or DOWN Condition checking.
ICMP Request using the trace Route Menu.
Bridging Mode
Static Routing
Console
Telnet
SNMP
Through the Serial Port Using the X-Modem Protocol
Using the TFTP over Ethernet Port
PWR, E1Sync, ALM, ETH_LINK, ETH_SPD, PPP_LNK
48V DC and 230V AC Dual power supply.
Redundant Power supply is ordering time Option. Redundancy of 5V DC for the Primary Power supply so that we can Connect External 5V Power Adaptor In case of Internal Power supply Fails.
Operating Temperature -5 to +55C
Operating Humidity 5% to 99%
Rugged Metallic Aluminum Casing as for the Field Conditions.
Mac Address Filtering (LAN Interface)
Auto MDI-X Support
System Clock : Internal or loop back timing
Number ports : 1 (E1 Interface)
Bit Rate : 2.048Mbps
E1 Interface Connectors : RJ45
Serial UP or DOWN Condition checking.
ICMP Request using the trace Route Menu.
Bridging Mode, Static routing(routing protocols)